OSTC Mk.2, 2N and 2C :  heinrichs weikamp forum The fastest message board... ever.
Legacy OSTC's 
OSTC2n (v2.70) Surface Interval display in Gauge mode.
Posted by: Liam ()
Date: October 25, 2013 05:22PM

Hi all. The answer to this may be a short no. But here it goes.

Does anyone know if it is possible to display the Surface Interval on the surface whilst using the OSTC2n in gauge mode?

When in one of the 'computer' modes it will do this. But in gauge mode it shows a duration of 00:00 at all times.


Thanks in advance.


Liam.

Options: ReplyQuote
Re: OSTC2n (v2.70) Surface Interval display in Gauge mode.
Posted by: heinrichsweikamp ()
Date: October 29, 2013 07:56AM

No, the surface interval resets to zero when all tissues are back to normal. Since they haven't changed in gauge mode the surface interval does not work here.

Regards,
Matthias

Options: ReplyQuote
Re: OSTC2n (v2.70) Surface Interval display in Gauge mode.
Posted by: Liam ()
Date: October 29, 2013 08:41AM

Matthias, many thanks for your reply.

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.