OSTC Mk.2, 2N and 2C :  heinrichs weikamp forum The fastest message board... ever.
Legacy OSTC's 
OSTC 2C O-ring size
Posted by: daro76 ()
Date: January 20, 2018 09:52PM

Hello everyone
I'm new on this forum, but I'm happy owner HW ostc 2c from last 4 years.
I think is time to replace USB plug o-ring. I'm not sure about the dimensions.
I measured the size of the plug (o-ring channel) and it says that I should fit an oring with dimensions: 9,5x1,5 Is this correct? If not-can anyone give me the correct dimensions?
regards
Dariusz

Options: ReplyQuote
Re: OSTC 2C O-ring size
Posted by: U-96 ()
Date: January 20, 2018 10:24PM

Hello Dariusz

According to an answer on the same question in this forum from May 29, 2015 there are two possible o-ring dimension (inside diameter x cross section):
10 x 1.3 mm, NBR 70 shore (old version)
8.5 x 2 mm, NBR 70 shore (new version)

Best regards
Michael

Options: ReplyQuote
Re: OSTC 2C O-ring size
Posted by: daro76 ()
Date: January 20, 2018 10:39PM

Thank you Michael smiling smiley

Options: ReplyQuote
Re: OSTC 2C O-ring size
Posted by: heinrichsweikamp ()
Date: February 02, 2018 05:26PM

Hi,

Sorry for the delay. If you need O-Rings please send me a mail: info@heinrichsweikamp.com and we'll send some out for free.

Regards,
Matthias

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.