The fastest message board... ever.
 
OSTC4 & CCR connection
Posted by: aligot ()
Date: February 06, 2017 09:31AM

Hello,

instead of the expensive ppO2 monitor device, do you plan to produce an adapter that can be directly put into the head of a rebreather to transform signal from the cells to optical one ?

Like a lot's of people I have an AP rebreather. I have O2 cell monitoring on the rebeather handset. I can get some cable out of the rebreather using, for instance adapter from tecme.de . If I connect my OSTC4 to this rebeather I'll have two ways to get cells reading. I don't need a third screen and I would prefer limit the number/size of devices I carry under water :-)

What can you suggest ?

Best regards,

A.

Options: ReplyQuote
Re: OSTC4 & CCR connection
Posted by: aligot ()
Date: July 26, 2017 03:53PM

Hello,

Do you have some specification about the optical link of the OSTC4 ? Are you able to provide them ?

I'm thinking about using an arduino to send the OSTC4 O2 sensor information.

Best regards,

a.

Options: ReplyQuote
Re: OSTC4 & CCR connection
Posted by: glance ()
Date: July 26, 2017 07:49PM

I think the protocol is the same as between the ppo2 monitor, hud and the ostc3, as described in:
[forum.heinrichsweikamp.com]


//Anton

Options: ReplyQuote
Re: OSTC4 & CCR connection
Posted by: heinrichsweikamp ()
Date: July 31, 2017 11:27AM

Hi,

Yes the protocol is identical.

regards,
Christian

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.