OSTC3, cR, sport and 2 :  heinrichs weikamp forum The fastest message board... ever.
OSTC's running hwOS 
New OSTC3 firmware 1.03 available for download
Posted by: heinrichsweikamp ()
Date: October 01, 2013 06:25PM

Hi all,

The new OSTC3-firmware 1.03 is now available for download: [www.heinrichsweikamp.com] - it can be installed using the "OSTC companion" (Available from the same site). Major changes are the new user-selectable colour schemes and the dynamic gaslist (See below) selectable in OC mode.

Hallo,

Die neue Firmware 1.03 ist nun verfügbar für den OSTC3: [www.heinrichsweikamp.com] - Diese wird wie immer mit dem "OSTC Companion" (Verfügbar auf der gleichen Seite) installiert. Wichtige Neuerungen sind die Benutzer-wählbaren Farbschema und die dynamische Gasliste, die im OC Modus anzeigbar ist.


- Select dynamic Gaslist with right button. All Gases not recommended for this depths are in red
- Wählen Sie die dynamische Gasliste mit der rechten Taste aus. Alle Gase, die für diese Tiefe nicht empfohlen werden sind rot dargestellt.


- The dynamic Gaslist updates itself automatically, Gas 3 is now breathable
- Die dynamische Gasliste aktualisiert sich automatisch, Gas 3 ist nun atembar


- The "Better Gas" is indicated in yellow automatically
- Das "Better Gas" (Für diese Tiefe vom Benutzer geplantes Gas) wird automatisch gelb markiert

Gruß/Best Regards,
Matthias



Edited 1 time(s). Last edit at 10/01/2013 06:28PM by heinrichsweikamp.

Attachments: OSTC_dyn_gaslist.png (8.4 KB)   OSTC_dyn_gaslist2.png (8.6 KB)   OSTC_dyn_gaslist3.png (8 KB)  
Options: ReplyQuote
Re: New OSTC3 firmware 1.03 available for download
Posted by: garylegge ()
Date: October 16, 2013 12:27PM

I am trying to do my first firmware upgrade. I have installed the companion software and connected my ostc3 but it is not then clear what I need to do to upgrade the firmware. Companion recognizes my ostc, which displays starting...done Service Mode enabled. I think it should show download mode enabled. What am I missing?

Regards

Options: ReplyQuote
Re: New OSTC3 firmware 1.03 available for download
Posted by: heinrichsweikamp ()
Date: October 16, 2013 04:39PM

Hi,

Almost done, you now need the new firmware file which can be downloaded here: [www.heinrichsweikamp.com]

Then upgrade using the "Upgrade Firmware..." button.

And yes, "Service mode enabled" is a correct message on the OSTC3 after clicking "Reconnect" in the OSTC Companion.

Regards,
Matthias

Options: ReplyQuote
Re: New OSTC3 firmware 1.03 available for download
Posted by: garylegge ()
Date: October 16, 2013 06:07PM

Done. Thanks, now have a question about deco planner but will start newtopic.

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.