OSTC3, cR, sport and 2 :
heinrichs weikamp forum
Attachments: MOD1.6.jpg (210.4 KB) VPlanner_2017-06-26_08-50-59.png (40.2 KB)
OSTC's running hwOS
Mod for first gas is wrong
Posted by:
KEngelstoft
()
Date: June 26, 2017 07:56AM
Hi, when editing a first/travel gas on OSTC3 the MOD is calculated based on ppO2 1.6 instead of 1.4 bar. This should only happen for deco gasses.
Best Regards,
Kasper
OSTC3 #576, replaced by OSTC3 #2827
Edited 2 time(s). Last edit at 06/26/2017 07:56AM by KEngelstoft.
Best Regards,
Kasper
OSTC3 #576, replaced by OSTC3 #2827
Edited 2 time(s). Last edit at 06/26/2017 07:56AM by KEngelstoft.
Attachments: MOD1.6.jpg (210.4 KB) VPlanner_2017-06-26_08-50-59.png (40.2 KB)
Re: Mod for first gas is wrong
Posted by:
heinrichsweikamp
()
Date: June 26, 2017 08:49AM
Hello,
The hwOS currently uses only one max. ppO2 setting for all gases. And the default for this is 1.60bar.
Regards,
Matthias
The hwOS currently uses only one max. ppO2 setting for all gases. And the default for this is 1.60bar.
Regards,
Matthias
Re: Mod for first gas is wrong
Posted by:
Ralph
()
Date: September 06, 2017 05:30AM
Hi all,
meanwhile, there are two settings, a ppO2 bottom max and a deco max, which are used dependent on the gases configured as deco gas or something else (first, travel).
BR
Ralph
meanwhile, there are two settings, a ppO2 bottom max and a deco max, which are used dependent on the gases configured as deco gas or something else (first, travel).
BR
Ralph
Sorry, only registered users may post in this forum.