OSTC 4 :  heinrichs weikamp forum The fastest message board... ever.
 
Simulator seems to continue at depth passing entered dive time
Posted by: chrisrms ()
Date: July 31, 2018 07:54AM

Hi,

I tested a 20 min. simulated dive at 50 m. Though after the 20 min. the simulated dives seems to go onwords at 50 m. it does not start ascending. Is this normal? Btw, on the OSTC4 under Information RTE 1.3 and OS 1.3.1 is stated.

Regards
Chris

Options: ReplyQuote
Re: Simulator seems to continue at depth passing entered dive time
Posted by: heinrichsweikamp ()
Date: July 31, 2018 10:53AM

Hi Chris,

This is normal. the bottom time in the simulator is only for the "Calculate Deco" results table, not for the real time simulator.

regards,
Matthias

Options: ReplyQuote
Re: Simulator seems to continue at depth passing entered dive time
Posted by: chrisrms ()
Date: July 31, 2018 11:26AM

Hi Matthias,

ah, ok, thanks for your feed-back.

So if I understand that right, one can not do a realtime simulation of a dive from beginning until end of dive. I mean, I set 20 min. at 50 m. and then activate "Start Simulator". I thought this would, after the 20 min. bottom time passed, start to simulate de ascend. But perhaps simulation of the ascend is something which is not needed/usefull?

Regards
Christoph

Options: ReplyQuote
Re: Simulator seems to continue at depth passing entered dive time
Posted by: heinrichsweikamp ()
Date: July 31, 2018 11:28AM

At the end of your desired bottom time, click SIM: -1m until you are at zero. And when "Ascent follows decostops" is checked, the unit will stop at all deco stops until they are cleared.

regards,
Matthias

Options: ReplyQuote
Re: Simulator seems to continue at depth passing entered dive time
Posted by: chrisrms ()
Date: July 31, 2018 11:48AM

Hi Matthias,

ok I understand now how it works, thanks for clarification!

With best regards
Christoph

Options: ReplyQuote


Sorry, only registered users may post in this forum.
This forum powered by Phorum.