OSTC3, cR, sport and 2 :  heinrichs weikamp forum The fastest message board... ever.
OSTC's running hwOS 

Pages: 12345...LastNext
Current Page: 1 of 127
Results 1 - 30 of 3793
Today
heinrichsweikamp
Hallo Hansjoerg, Someone else reported us a similar issue. Seems that there is some issue with dive mode detection in high altitude conditions in the 1.5.0. I'll check... OSTC4 allow a hard reset: - place on charger - toggle a reset with a magnet on the left housing side of the OSTC4 regards, Matthias
Forum: OSTC 4
6 days ago
heinrichsweikamp
Hi, We'll make a video sometimes. Basically, you need to push first a bit, then start turning. regards, Matthias
Forum: OSTC3, cR, sport and 2
9 days ago
heinrichsweikamp
Hi, Seems that the battery leaked and this should be checked at our place. We can send you a free rental unit for your course so you don't have to wait for your OSTC4 to come back. regards, Matthias
Forum: OSTC 4
9 days ago
heinrichsweikamp
Hi, As can be read in the thread above, the only real "issue" is that you have to select "OSTC 3+" in the current OSTC Companion and not "OSTC sport" as you were used to do. Is this really that problematic as your last post indicates? Besides that, the 10.60 is way better and much mode powerful then the older version. use the alternative layout and almost any
Forum: OSTC3, cR, sport and 2
10 days ago
heinrichsweikamp
Hi, In this case we can have a look at the unit at our place, I'll write you an email about this. regards, Matthias
Forum: OSTC3, cR, sport and 2
11 days ago
heinrichsweikamp
Stardrowned Wrote: ------------------------------------------------------- > It was mentioned in another thread, that you have > to select "ostc3+" as model. To install the firmware, it actually does not matter what you select: OSTC cR, OSTC 3, OSTC 3+, OSTC 2, OSTC sport.... as long as the correct port is set (Small gear Icon). Just click on "Upgrade Firmware"
Forum: OSTC3, cR, sport and 2
11 days ago
heinrichsweikamp
Thread updated for 10.60
Forum: OSTC3, cR, sport and 2
11 days ago
heinrichsweikamp
Hi, One user reported a freeze in the surface menu (For the latest beta) at some point and we were able to reproduce the error now. As soon as I'm 100% sure the error is fixed, we'll publish the new stable. Regards, Matthias
Forum: OSTC3, cR, sport and 2
11 days ago
heinrichsweikamp
Hi, It may be coincidence but the old OSTC sport with the red buttons need a quality 1,5V Battery (Like the Energizer E2 AA) or a 3,6V Battery for the bluetooth to operate properly. The Bluetooth module inside still has the same firmware as before (This part is never updated with a normal OSTC firmware update) regards, Matthias
Forum: OSTC3, cR, sport and 2
11 days ago
heinrichsweikamp
RonMacRae Wrote: ------------------------------------------------------- > 1) What's new in 10.58? Some changes for the old OSTC sport with red button (And Bluetooth 2.0 only) > 2) Why does the computer go back to German? Because English is now the default language again and you have selected the alternative language in the last version and this setting was imported from t
Forum: OSTC3, cR, sport and 2
11 days ago
heinrichsweikamp
Hello Peter, What OSTC model is it (exactly)? Regards, Matthias
Forum: OSTC3, cR, sport and 2
11 days ago
heinrichsweikamp
Hi, You need to "pair" the OSTC in the Androids Bluetooth dialog first. Regards, Matthias
Forum: OSTC3, cR, sport and 2
13 days ago
heinrichsweikamp
Yes, it's actually very simple once you removed the backplate. There are four small pins holding the buttons, pull these out with a pair of grippers and you can remove/clean/replace the buttons. They are magnetic and so they attract ferrous particles. Cleaning them from time to time usually is enough. regards, Matthias
Forum: OSTC3, cR, sport and 2
14 days ago
heinrichsweikamp
Hallo Patrick, Das Feature ist zur Zeit deaktiviert, es kommt vielleicht in einer der nächsten Versionen zurück. Wir haben sehr viel am Unterbau optimiert, aber auch der aktuelle Tauchmodus sollte sich "auf Kommando" beenden lassen ohne das es zu unerwünschten Effekten kommt. Das wurde aber nicht ausführlich getestet, daher ist dies zunächst deaktiviert. Gruß, Matthias
Forum: OSTC3, cR, sport and 2
18 days ago
heinrichsweikamp
Alternativ (Wenn das RTE jetzt drauf ist, es ist normal, dass das 2x angestoßen werden muss), SYS2 -> Reset -> Maintenance -> Restore Battery. Gruß, Matthias
Forum: OSTC 4
20 days ago
heinrichsweikamp
D_Kl Wrote: ------------------------------------------------------- > danke für die Antwort. Aber hier ist aber eben > genau "der Fall" von mir beschrieben, wo im > Oberflächenmodus eben die Anzeige nicht (+/- 5 > hPa) angehalten wird. Hallo, Die Sensoren "rauschen" alle etwas (Je nach temperatur bis zu +/-10mbar/hPa). Das wird (und wurde schon immer) an
Forum: OSTC3, cR, sport and 2
21 days ago
heinrichsweikamp
Hi, please check if the compass calibration (The compass is been used in sleep mode to detect movement) works. regards, Matthias
Forum: OSTC3, cR, sport and 2
21 days ago
heinrichsweikamp
Hi, "impossible to download log to PC or Smartphone." - any more error messages or details would be appreciated. One wild guess: Are you using 3,6V or (cheapy) 1,5V batteries. Under-performing 1,5V batteries might not be able to provide enough current for a stable bluetooth operation. regards, Matthias
Forum: OSTC3, cR, sport and 2
21 days ago
heinrichsweikamp
Hallo, Einfach "OSTC3+" wählen. Der neue Companion wird nur noch zwischen OSTC4 und "nicht-OSTC4" unterscheiden, da alle Geräte jetzt softwareseitig kompatibel sind. Gruß, Matthias
Forum: OSTC3, cR, sport and 2
26 days ago
heinrichsweikamp
Gastype = Deco and Change depth configured for the deco gas? And: Firmware version? Regards, Matthias
Forum: OSTC3, cR, sport and 2
26 days ago
heinrichsweikamp
Clownfish Wrote: ------------------------------------------------------- > Used new beta today, noticed that when using the > alternate display, the NDL does not show anything. > Otherwise all worked okay (only 27 metre dive). Fixed already for the stable release. regards, Matthias
Forum: OSTC3, cR, sport and 2
27 days ago
heinrichsweikamp
Tastenchef Wrote: ------------------------------------------------------- > Amy Suggestion when Beta ist over ? > So we could geht the Brand new Release Version of > f Tech? I think 1-2 weeks is realistic. How should we call the new version 3.05? 3.10? 4? regards, Matthias
Forum: OSTC3, cR, sport and 2
27 days ago
heinrichsweikamp
Handbuch kommt... Die Handbuchschreiberin war in den letzten paar Wochen mit einem anderen Projekt beschäftigt. Gruß, Matthias
Forum: OSTC3, cR, sport and 2
27 days ago
heinrichsweikamp
> I have the version with red buttons, so no more > Bluetooth option, so more possibility to connect > to the firmwar 10.57 and put the correction in > place! Please read my post above in this thread: Date: August 23, 2019 01:37PM Which has a solution to this issue. regards, Matthias
Forum: OSTC3, cR, sport and 2
27 days ago
heinrichsweikamp
Read the thread for the update which has the solution for this:
Forum: OSTC3, cR, sport and 2
27 days ago
heinrichsweikamp
RonMacRae Wrote: ------------------------------------------------------- > the current depth. Is this a deliberate change? I > downloaded the manual again today and it still > shows the ascent bars. > Should I still be getting the vertical bar beside > the depth? Enable them in Menu -> Settings -> Display Settings -> More -> Speed Graph > I was also gett
Forum: OSTC3, cR, sport and 2
4 weeks ago
heinrichsweikamp
This is the 10.56 with the NDL in the big layout mode fixed, yes. There are no new features or other changes. regards, Matthias
Forum: OSTC3, cR, sport and 2
4 weeks ago
heinrichsweikamp
Hi all, the NDL display in big layout mode has been fixed and the bluetooth in the old OSTC sport (red buttons), as well. Sorry for the inconvenience here and thanks for the reports here about that. You can download the 10.57 as usual and I have updated this thread. We'll remove some post as requested by the users about this then next week. To get the 10.57 installed on RED button O
Forum: OSTC3, cR, sport and 2
4 weeks ago
heinrichsweikamp
Continue here:
Forum: OSTC3, cR, sport and 2
4 weeks ago
heinrichsweikamp
Hello, The new hwOS sport firmware 10.60 is now available for download: The following changes have been applied: [10.60] BUGFIX: Surfacemode could freeze in some hardware versions BUGFIX: Potential issue with Bluetooth in older OSTC sport models CHANGE: Default language in EN/DE version is English again [10.58] BUGFIX: Version number was not shown in main screen BUGFIX: Button f
Forum: OSTC3, cR, sport and 2
Pages: 12345...LastNext
Current Page: 1 of 127

This forum powered by Phorum.