forum.heinrichsweikamp.com

Hi after one day of charge the battery level is 97% .
The charger works, there is no problem.

Fabrizio

Hi I've tried to charge the ostc2 ,battery at 83%, by the wireless pad , connetcting it to a PC USB at first and then to a cell phone charger (2,1 A) USB; but after a night of charging the battery status is 85% . The pad is very hot but the led blinks green. It seem that pad do not charge the unit ...

G1: is the bottom gas I use (AIR or TRIMIX, in the last dive it was AIR)
G4 and G5 are a residual of old configuration (usually i don't use them ) , once I've used G4 as first gas leaving G1 Trimix inactive (here I've noticed the unexpected behaviour which caused this post).
G2: is the first deco ...

Thanks Matthias,
your explanation resolves fully the question.
i didn't know that first gas requires the depth set to 0.
As usual HW support is rapid,precise and clear.

Best regards

I know it; in this way are active togheter AIR(G1) as first gas and AIR (G4).
I know that this configuration has no utility, but it is the residual of a previous configuration which produces no damage

To activate the gas.
I Know it is not necessary because the AIR is active as first gas; the result is that i've two air active.

Gas List:

G1 AIR 21 at 0
G2 NX 47 at 21
G3 NX 98 at 6
G4 AIR 21 at 1
G5 AIR 21 at 0

G5 is obviously inactive because change is set to 0
If G1 is the first gas, the simulator consider G1,G2 and G3 to calculate deco plan.
if G4 is the firstgas and G1 became inactive, the simulator calculate the dive ...

Ok.... you are a programmer ))))

OSTC 6243
Firmware 2.5
Using the simulator to plan some dives I've noticed that if the first gas is the first of gas list, the planning it's ok, if in the gas list I put first deco gases and after the first gas, the simulator doesn't consider deco gases but only the first gas.
Is it a bug ?