forum.heinrichsweikamp.com

Thank you for the detailed explanation.

Hi, after updating to 2.96 on my OSTC3, the N2 and He saturation graph look incorrect:
1) It looks like there is some N2 saturation, even though I haven't dived for 11 days.
2) He graph look like points at 100% instead of lines from 0 to 100%/1 bar.
Please have a look at the attached picture.

Hi, when editing a first/travel gas on OSTC3 the MOD is calculated based on ppO2 1.6 instead of 1.4 bar. This should only happen for deco gasses.

Please don't remove the possibility of getting an average depth readout. It is needed for validating the OSTC deco plan against ratio deco rules.

Hi! I do like the part about depth changing to red if ppO2 is exceeded. I don't like the Dive time and NDL/TTS times in yellow (“attention_color”). It should just be the normal color, as there is nothing urgent about these during normal dives. The separator lines should be disabled per default in my...

What kind of battery did you use, the Saft?

Have a look in the repository: heinrichsweikamp-osct3_code\doc\ostc3_interface.odt.

Kasper

Hi! In my opinion, adding the MOD and ppO2 max settings to the in-dive display is not adding any value, it just clutters it with unneccesary information. I vote that it should not be added. The current pO2 level should be enough.

Hi Matthias,

The OSTC3 is now listed as being out of stock, when do you expect to have more in stock?

Thanks,
Kasper

Thank you

Hi!
After a dive with my OSTC 2C I noticed that the blue LED on the back of the computer was blinking. What does that mean? The manual does not mention this as far as I know, but does identify it as a LED-Statusdisplay.

Thanks,
Kasper

I did an hour long dive yesterday and 2 more dives today, maximum depth 11 and 17 meters, total duration 48 minutes. The computer did not turn on at all and does not react to key presses I believe it is time to send it back to HW.

Update: The computer has been unable to turn on for more than 3 days now (on the surface). I tried replacing the battery with another brand new SAFT battery and the display came on with the 'New battery' menu. I selected 3,6 volt and then the screen went black again. I have been unable to turn it on...

Hi! My OSTC3 is unable to turn on after a dive, even with a brand new SAFT battery installed. It starts fine after having been on the surface for about a day. I have not found moisture inside the battery or USB compartment. When in unresponsive state, I can't get a USB connection to work either, jus...

Hi! Instead of all users having to visit the website to check for new firmware, I suggest an email distribution list where an email is sent to all subscribed users when new firmware is available...

Best Regards,
Kasper