forum.heinrichsweikamp.com

Every profile is empty, now.

The same problem with my OSTC4. SW 1.4.8

Don't working.

It seems strange to me, too.
Both my units, #439 (flooded at 30m) and current #152 have the same back plate.

lionelw Wrote: The photo only shows two > screws (which seem to be in the correct position > for my unit but cannot see if there are also > another two for the other long edge (under the > mount, maybe obscured by the bungee). How do I get > hold of one of these? There is no other screws on the lowe...

lionelw Wrote:
> Can you please send me photo of the plate.

Here you are.

lionelw Wrote:
> Can you please send me photo of the plate.

Hi, I will send photos as soon as my unit returns from service. But both my units #439 and #152 had that notch. I had not any problems witch charging.

lionelw Wrote:
> I'd suggest that you provide a plastic template to
> hold it in position. I'd be happy to share a
> design once I have found a simple solution that
> works reliably.
Newer versions of OSTC4 have a notch in the bottom plate to keep the charger just in place

Next dive, same problem.
Today @ 23m, 9' of dive display was switched off. After another 15' it starts fast scrolling at normal brightness. After few minutes of scrolling switch to normal status and works fine to the end of the dive (76').

Oryginal firmware 1.3.5 beta
Battery 45%

Today during dive at 20m, after about 5 minutes my OSTC4 was start to fast scrolling display from left to right. After a few seconds of scrolling display hangs and was start to dimming to totaly blank. Only backlight was be shown. Non response to buttons. And afer another 10 minutes, as sudenly as i...

(tu)

Hi,
My OSTC4 died in a similar way today on its very first dive...
First, at 30m it showed extra white, horizontal lines on display, and a few seconds later turn black with backlit (foto).


Regards

You should use OSTC Tools.

Look here: read.php?7,18363,18367

So, it is possible to do a wireless communication with tank pressure sensors or reb cells using this coil antenna?

Inside OSTC4, below a plastic backplate there is a RFID transponder antenna, made by NEOSID, like these: http://www.neosid.de/fileadmin/user_upload/download/NEOTAG-Produktinfo-Transponderantenna.pdf I hope it is not for any RFID transponder but for future underwater radio communication with tank pre...

Hi
What is a RFID transponder antenna in OSTC4 for?

Regards
Darek

It would be a shame not to use more such a wonderful LCD display. My proposal is to make a picture viewer for i.e. dive site maps. In the simplest solution for one format (PNG?) and exact one 800x480 pixel resolution. In the rich solution for many formats (i.e. PNG, JPEG and BMP) and any resolution ...

I think it will be a great idea. Especially because I just changed from XDEEP BLACK, where a descent speed indicator occupied the entire height on the left side of the display, was customizable and was very useful.

Regards
Darek