forum.heinrichsweikamp.com

Dear OSTC Development Team,
First of all, I would like to thank you for your continued work and support on the OSTC dive computers and their software.
Since software version 3.34, I have noticed that the underwater compass display has been reduced to a simple numerical degree value only. While ...

Thank you for the response. I’ve installed version 3.34, and now the compass works underwater.
However, it’s a pity that the display only shows a number in degrees. The previous analog display was more ergonomic.”

Thank you for the response. I’ve installed version 3.34, and now the compass works underwater.
However, it’s a pity that the display only shows a number in degrees. The previous analog display was more ergonomic.”

Compas shows 000 when under water ( it works well on the surface)

Hello,
This morning, I updated my OSTC+, using the iPhone app, and I noticed that the installed firmware version is now 3.33.
Could someone please explain the differences between versions 3.32 and 3.33?
Thank you very much in advance for your help.
Kind regards,
Gérard

It is clear
Thanks

Thanks for your answers,
But I'm surprised, Sunday evening, I had 18h of "desat" but no "nofly" ??
Next week I will dive a lot, so , I will check more carefully.

OSTC Plus, 3.20 release.
Where is the indiction of "no fly" on the surface screen ?
I dived today, I have the "desaturated time" is showed but not the "no fly time" Is it the same ?
Thanks for your help
regards
Gérard

Ok, clear.
In the meantime, I will use only GF.
Thanks

Hello,
I have a OSTC+
With this new release, I can't set the S/D in ecotype ZH-L16* (without GF)
For exemple, I choose 120% for Saturation, and 80% for desaturation in the menu Deco Setup. But no change on the display, the previous setting 110/90 stays (even if I take off the battery and fit it ...