Hello all,
I am using an Ostc3 with the Ppo2 monitor device. Since upgraded to 3.12 I am not able to find how to activate the cell reading..... I have probably missed something but I double checked all menus and didn't find anything :-(
:D thx in advance for the help and have a nice weekend!
F3.12 ccr mode with Ppo2 monitor
Re: F3.12 ccr mode with Ppo2 monitor
Hi,
have you checked CCR/pSCR Setup -> more -> S8 Input : check set to Digital ?
Older firmware had auto-detection which wasn't 100% reliable, to its now manual selection.
have you checked CCR/pSCR Setup -> more -> S8 Input : check set to Digital ?
Older firmware had auto-detection which wasn't 100% reliable, to its now manual selection.
Last edited by Ralph on Monday 24. August 2020, 13:06, edited 2 times in total.
Re: F3.12 ccr mode with Ppo2 monitor
Hello,
Pb solved thx you! The fix was :
1)reupload the proper firmware (ie there is a version cr and tr) and most likely i initially pushed the wrong version.
2)verify the parameter S8 input and set it to Digital.
Thx you a lot for your help,
Rémi
Pb solved thx you! The fix was :
1)reupload the proper firmware (ie there is a version cr and tr) and most likely i initially pushed the wrong version.
2)verify the parameter S8 input and set it to Digital.
Thx you a lot for your help,
Rémi