Problems after update

The big one
Locked
Grinch
Posts: 6
Joined: Thursday 12. December 2019, 21:02

Problems after update

Post by Grinch »

Helo,
I have OSTC 4. Was no problems and still believe is one of the best computers :) Still have small problems, hope I didn´t do any thing wrong. After last update I lost in computer possibility to change boton sensetivity and lost Helium MIX gases... :geek:

What I checked afret update i have everything what i need but those i lost. How I can get it back?

Do i need different update or I lost them forewer?

Thank you so much for help!!!!
heinrichsweikamp
Posts: 4370
Joined: Sunday 13. May 2007, 18:07

Re: Problems after update

Post by heinrichsweikamp »

Hi,

You installed the 1.5.4, right? There is, of course, still the trimix setup and the buttons menu in the SYS2 menu. And there are no plans to change this :D

I consulted my crystal ball and after staring a few hours into it we came up with the following here:
- You have an OSTC plus, not OSTC 4
- You run it on 1,5V batteries instead of the rechargeable 3,7V battery
- You accidentally installed the "hwOS sport" firmware instead of the "hwOS tech"

Right?

If yes:
a) go to the correct forum, please: viewforum.php?f=6
b) re-install the tech firmware with the App: viewtopic.php?f=6&t=14509
c) use the recommended 3,6V rechargeable battery in the OSTC plus

Regards,
Matthias
Grinch
Posts: 6
Joined: Thursday 12. December 2019, 21:02

Re: Problems after update

Post by Grinch »

what a f..ng idiot :lol: :lol: :lol: :lol: thank you so much... all pints after i did it wrong. Thank you for your advice. At specially about battery, thank you, as i didn´t know i need to use only rechargebla one.

Thank you again so much for help
heinrichsweikamp
Posts: 4370
Joined: Sunday 13. May 2007, 18:07

Re: Problems after update

Post by heinrichsweikamp »

No worries, thanks for the feedback.

Matthias
Locked