hi,
i have small problem with nodeco time calculation during
dive simulation:
1. start simulation
2. go immediately to 33m
3. dive time is 0min
- nodeco is 9min, after few seconds changes to 10min
- after several seconds nodeco changes to 8min
3. wait until dive time is 1min
- nodeco is 8min but after a while it changes to 9min
- several seconds before change to 2min dive time, nodeco changes to 7min
4. dive time changes to 2min
- 7min nodeco
- after a while nodeco changes to 8min
- after a while nodeco changes to 6min
this is L16-GF OC algorithm with first deco stop set to 6m.
firmware ver. 1.29 (the same was in case of ver. 1.26).
i would expect more immediate nodeco time changes (synced
with dive time change) and nodeco shall not jump within
one minute like 8min->9min->7min, imho.