Hello,
The new OSTC3, cR and OSTC 2 firmware 1.77 is now available for download: http://www.heinrichsweikamp.com/?id=479&version=de (German) or http://www.heinrichsweikamp.com/?id=479&version=en (English)
This update only affects cR users using the analog inputs. The calibration of these were ignored in the 1.76 ("---" was shown instead of the correct values) in surface mode.
Details on the new hwOS: http://www.heinrichsweikamp.com/?id=335
Regards,
Matthias
hwOS for OSTC3, cR and OSTC 2: New 1.77 released
-
heinrichsweikamp
- Posts: 4376
- Joined: Sunday 13. May 2007, 18:07
-
heinrichsweikamp
- Posts: 4376
- Joined: Sunday 13. May 2007, 18:07