1) Still need to reset all settings/reboot firmware/reboot rte few times to successfully load new RTE firmware sections.
- formerly I set it 'custom text' and five gas settings, vpm+2, metric/red view...
- how to perform to section3(RTE part) successfully, following methods this
- still can't upgrade via dctool(win/mac both: hw_ostc3_firmware_readfile4). used companion b8.
2) If reboot RTE, button sensitivity not works well(if 86 show, but really below 50)
Other settings menu values jumps up/down when I scrolling the items. also often stuck in menu cursor when traversing the menus. *actually I think reset settings -> reboot firmware not works.
3) Temperature legend still draws wrong
[img]https://s22.postimg.org/pcemy6mjl/image.jpg[/img]
[img]https://s22.postimg.org/c9j0ewwbl/image.jpg[/img]
[img]https://s22.postimg.org/rwa9saa3l/image.jpg[/img]
[img]https://s22.postimg.org/46ku3lbq9/image.jpg[/img]
[img]https://s22.postimg.org/jgkpas78h/image.jpg[/img]
[img]https://s22.postimg.org/v6yms600x/image.jpg[/img]
[img]https://s22.postimg.org/c1vfbw9wh/image.jpg[/img]
[img]https://s22.postimg.org/ekh4ckvmp/image.jpg[/img]
[img]https://s22.postimg.org/3m5uue71d/image.jpg[/img]
[img]https://s22.postimg.org/5s05owaht/image.jpg[/img]
1.1.8 update reports
-
- Posts: 4376
- Joined: Sunday 13. May 2007, 18:07
Re: 1.1.8 update reports
Hello.
Thank you for your feedback. Recalibration of the buttons after RTE update and the RTE update itself will be looked deeper. I will check what makes all the trouble directly on the restart after the RTE update process.
The new temperature scale code does not display 1/10 values but uses them internally. For the smale range you use the scaling routine needs an update.
The best update software (the one I use) is the OSTC Companion and can be found on OSTC_Planner_Webpage free of charge. It works witout any issues. We are using it on many working places at our company. I don't experience any issues with the current beta 8.
regards,
Christian
Thank you for your feedback. Recalibration of the buttons after RTE update and the RTE update itself will be looked deeper. I will check what makes all the trouble directly on the restart after the RTE update process.
The new temperature scale code does not display 1/10 values but uses them internally. For the smale range you use the scaling routine needs an update.
The best update software (the one I use) is the OSTC Companion and can be found on OSTC_Planner_Webpage free of charge. It works witout any issues. We are using it on many working places at our company. I don't experience any issues with the current beta 8.
regards,
Christian