VPM-B difference OCTS and subsurface

OSTC running hwOS4 Firmware
Post Reply
tdewilt2
Posts: 10
Joined: Wednesday 22. September 2021, 23:12

VPM-B difference OCTS and subsurface

Post by tdewilt2 »

Hi

I have both the OSTC 4 and subsurface on VPM-B +2. if I look at my last dive (nx30) I see subsurface calculates a ceiling but the OSTC4 did not. can anyone explain this difference?

thx in advance,

Teun
Attachments
Scherm­afbeelding 2023-01-17 om 21.22.15.png
Walde
Posts: 19
Joined: Thursday 4. November 2021, 12:03

Re: VPM-B difference OCTS and subsurface

Post by Walde »

Just to make sure, do you have "Draw dive computer reported ceiling red" selected on subsurface?
It's at preferences -> tech setup -> ceiling display setup
tdewilt2
Posts: 10
Joined: Wednesday 22. September 2021, 23:12

Re: VPM-B difference OCTS and subsurface

Post by tdewilt2 »

the computer ceiling is on in subsurface, during the dive I also had all the time more then 5 minutes NDL
tdewilt2
Posts: 10
Joined: Wednesday 22. September 2021, 23:12

Re: VPM-B difference OCTS and subsurface

Post by tdewilt2 »

Matthias Anny clue?
Divert
Posts: 17
Joined: Friday 24. May 2024, 00:06

Re: VPM-B difference OCTS and subsurface

Post by Divert »

I don't know the answer but last dive I did, I was using Bühlmann ZH-L16 with GF low = 30 and GF High = 80 and had 2 mintues of Deco at 6m depth, switched to VPM +3 and it showed NDL = 50 minutes or something like that!!!!

I was very surprised, switched it back to Bülhmann to finish the dive but now I am very confused about using VPM

Humberto
Post Reply