forum.heinrichsweikamp.com

Hi Matthias,
[left][/left]
Thanks for V1.20 update.
[left][/left]
After the update V1.20 I noted a display bug where the last deco stop value (3m) remains on the various surface mode screens, See photos attached,
[left][/left]
This bug exist only for the French language,
[left][/left]
I don't think that this text “Dernier Palier” was modified with V1.20
[left][/left]
Nota: I must do reboot mode before being able to work my OSTC3 with my PC under windows7 to update V1.20, I use reboot mode afterwards also, I don't know if that been able to affect this display Bug,
[left][/left]
I have seen also display 50% saturation of all N2 tissus with the 1st reboot mode after update V1.20 but I couldn't reproduce this problem another time? After the desaturation was done normally? See photo attached,
[left][/left]
Question:
[left][/left]
In the mode “Quit” of the simulator for dive times more than 1 mn, there is always Time info very close to 04:55 - See photo attached,
[left][/left]
What is this time info?
[left][/left]
Regards
[left][/left]

ClaudeDive Wrote:
> I don't think that this text “Dernier Palier”
> was modified with V1.20

It was - and is too long now. That results in this kind of issues.

The "end-of-dive" timer hasn't been changed. It 5min normal, in simulator it's five seconds or so.

Regards,
Matthias

Hi Matthias,
[left][/left]
For remove this Display problem, you can replace “Dernier Palier:" with :
[left][/left]
""Dern. Palier:"" ( preferably ).
[left][/left]
or
[left][/left]
""Dern.Palier:""
[left][/left]
Regards
[left][/left]

Ok, 1.21 is online