forum.heinrichsweikamp.com

First gas active - Air
[img]file.php?2,file=642,filename=1.png[/img]

[img]file.php?2,file=643,filename=2.png[/img]

Second gas is inactive.

[img]file.php?2,file=644,filename=3.png[/img]

Making second gas active:
[img]file.php?2,file=645,filename=4.png[/img]

And the result is:
[img]file.php?2,file=646,filename=5.png[/img]

Which you can see on first screen also:
[img]file.php?2,file=647,filename=6.png[/img]

But in the simulator the gas is shown propperly:
[img]file.php?2,file=648,filename=7.png[/img]

And it is possible to change the gas:
[img]file.php?2,file=649,filename=8.png[/img]

But after returning to gas setup menu, second gas is still shown as inactive:
[img]file.php?2,file=650,filename=9.png[/img]

The same goes with other inactive gases. Their color becomes yellow only when they are set to be the first gas.

you need to define a depth change and the gas will be active,
[left][/left]
Regards,
[left][/left]

OK. Now I get it...

nodekh, did you read user guide ?

Yes, but didn't learn it as a poem. Should have done it...

Maybe someone could remove this thread?