OSTC3: New 1.62beta firmware released
Posted: 10 Nov 2014, 14:56
Hello,
Today, the new 1.62 beta firmware for the OSTC3 has been released: http://www.heinrichsweikamp.com/?id=162&version=en
This update is targeted at CCR divers since it includes numerous new features for CCR divers:
CHANGE: (Slightly) reduce current consumption in Eco and sleep mode
NEW: Allow auto-return from setpoint fallback
BUGFIX: O2 > 99% was not configurable from the PC
BUGFIX: Quit Apnea mode on the surface manually
BUGFIX: Check min and max values after PC configuration properly
CHANGE: Longer timeout (4 min) for calibration menu and Surface mode (CCR Modes)
NEW: Show Bailout Gas List in Surface mode (CCR Modes)
CHANGE: Faster update rate for sensor display in surface mode
Please install the firmware using the "OSTC Companion" software.
Best regards,
Matthias
Today, the new 1.62 beta firmware for the OSTC3 has been released: http://www.heinrichsweikamp.com/?id=162&version=en
This update is targeted at CCR divers since it includes numerous new features for CCR divers:
CHANGE: (Slightly) reduce current consumption in Eco and sleep mode
NEW: Allow auto-return from setpoint fallback
BUGFIX: O2 > 99% was not configurable from the PC
BUGFIX: Quit Apnea mode on the surface manually
BUGFIX: Check min and max values after PC configuration properly
CHANGE: Longer timeout (4 min) for calibration menu and Surface mode (CCR Modes)
NEW: Show Bailout Gas List in Surface mode (CCR Modes)
CHANGE: Faster update rate for sensor display in surface mode
Please install the firmware using the "OSTC Companion" software.
Best regards,
Matthias