Hi,
I would like to understand the difference decompression plans of these three software. Can you help me please?
Gas Nx26
Dive: 42m 29'
ZH-L16 + GF (70% 85%)
OSTC 3 ZH-L16 (/C I think)
9m --> 5'
6m --> 9'
3m --> 21'
Total deco stop --> 35'
DTR --> 40'
CNS --> 19%
OTU's --> NA
iDecoPro (ZH-L16/C)
12m --> 1'
9m --> 4'
6m --> 7'
3m --> 14'
Total deco stop --> 26'
DTR --> 28'
CNS --> 20%
OTU's --> 42
PastoDeco (ZH-L16/C)
12m --> 1'
9m --> 4'
6m --> 7'
3m --> 19'
Total deco stop --> 31'
DTR --> 35'
CNS --> 19,5%
OTU's --> 46,4
Deco Plan difference (OSTC3 / iDecoPro / PastoDeco)
Re: Deco Plan difference (OSTC3 / iDecoPro / PastoDeco)
Hello,
It's me again
I add MultiDeco model to this comparative
Dive: 42m 29'
ZH-L16 + GF (70% 85%)
- First dive Gas Nx26
- Second dive Gas Nx26 + Nx70 (9m)
Why this difference please?
It's me again
I add MultiDeco model to this comparative
Dive: 42m 29'
ZH-L16 + GF (70% 85%)
- First dive Gas Nx26
- Second dive Gas Nx26 + Nx70 (9m)
Why this difference please?
-
- Posts: 4379
- Joined: Sunday 13. May 2007, 18:07
Re: Deco Plan difference (OSTC3 / iDecoPro / PastoDeco)
Hi,
It's difficult to say why there are differences without knowing the used code in detail. Our code is here: https://bitbucket.org/heinrichsweikamp/ ... at=default and we use the ZH-L16C without any special modifications.
Regards,
Matthias
It's difficult to say why there are differences without knowing the used code in detail. Our code is here: https://bitbucket.org/heinrichsweikamp/ ... at=default and we use the ZH-L16C without any special modifications.
Regards,
Matthias
Re: Deco Plan difference (OSTC3 / iDecoPro / PastoDeco)
OK thank you for your response.
cf. attached file for information.
With Nx70 bloc for deco, decompressions process are approximatively same.
cf. attached file for information.
With Nx70 bloc for deco, decompressions process are approximatively same.