forum.heinrichsweikamp.com

After successfully updating my OSTC2n many times with new firmware, I have just tried to update from 3.0 to 3.02 and am stuck on the 'Bootloader Please wait' screen, been there for 15 minutes!

Read all the posts about the bootloader software but the PIC is not found while it is frozen like this, so I cannot reapply the update - need a reset perhaps?? Use a magnet or let the battery go flat??

Ok, tried a magnet and BootLoader 1 and have recovered (phew)

Problem was caused by Bootloader 2.0 I think, when I try a web download
I get a message

HeinrichsWeikamp Bootloader v2
www.heinrichsweikamp.com
Support: info@heinrichsweikamp.com
--------------------------------------------------------------------------------------------------
Looking for http://www.heinrichsweikamp.net/autofir ... latest.hex
Could not access site information

I have done a manual download and update with 3.02 (again) and this time it worked but it would be good to get the web download working??

Thanks anyway