Hello,
does the OSTC Sport makes deepstops? I made a 40 meter dive and I had a little deco (2min, 3m) but there was no deepstop. I didn´t found anything about in the manual.
The DECO-settings are:
ZH-L16+GF
GF high 80%
GF low 30%
Firmware 10.15
no gaschanges
used gas: air
Is it possible to change the settings to make deepstops?
best regards
Seb
OSTC Sport deepstop
Re: OSTC Sport deepstop
Hello,
you will have kind of deep stops ( at least deeper then now ) with selecting conservatism +1 or +2 ( GF low 20 ).
The smaller GF low the deeper the first stop.
Reiner
you will have kind of deep stops ( at least deeper then now ) with selecting conservatism +1 or +2 ( GF low 20 ).
The smaller GF low the deeper the first stop.
Reiner
-
heinrichsweikamp
- Posts: 4376
- Joined: Sunday 13. May 2007, 18:07
Re: OSTC Sport deepstop
Seb Wrote:
> Is it possible to change the settings to make
> deepstops?
This question is asked several times/week (Not in the forum but via mail): The OSTC does not make "Pyle" or "Half of max. Depth" deepstops.
Only stops required by the deco algorithm are shown (Besides the Safety Stop). If you want to stop deeper then lower the GF low value after reading this: http://www.rebreatherworld.com/showthre ... or-Dummies
Regards,
Matthias
> Is it possible to change the settings to make
> deepstops?
This question is asked several times/week (Not in the forum but via mail): The OSTC does not make "Pyle" or "Half of max. Depth" deepstops.
Only stops required by the deco algorithm are shown (Besides the Safety Stop). If you want to stop deeper then lower the GF low value after reading this: http://www.rebreatherworld.com/showthre ... or-Dummies
Regards,
Matthias