hwOS for OSTC3, cR and OSTC 2: New 1.80 released
Posted: 19 May 2015, 10:44
Hello,
The new OSTC3, cR and OSTC 2 firmware 1.80 is now available for download: http://www.heinrichsweikamp.com/?id=479&version=de (German) or http://www.heinrichsweikamp.com/?id=479&version=en (English)
BUGFIX: Increase timing tolerance for S8 HUD (cR only)
CHANGE: increase min input voltage from 1,2mV to 1,9mV (cR only)
CHANGE: adjust menu for different hardware versions (OSTC 2)
CHANGE: Automatically abort connection fail after 2mins (Bluetooth only)
BUGFIX: Fast Gas change near the ppO2 limit could cause switching to a non-available Gas #0
CHANGE: Code now called hwOS officially
BUGFIX: There was a 1:4096 chance that a portion of a dive was not stored correctly resulting in download issues
Details on the new hwOS: http://www.heinrichsweikamp.com/?id=335
Regards,
Matthias
The new OSTC3, cR and OSTC 2 firmware 1.80 is now available for download: http://www.heinrichsweikamp.com/?id=479&version=de (German) or http://www.heinrichsweikamp.com/?id=479&version=en (English)
BUGFIX: Increase timing tolerance for S8 HUD (cR only)
CHANGE: increase min input voltage from 1,2mV to 1,9mV (cR only)
CHANGE: adjust menu for different hardware versions (OSTC 2)
CHANGE: Automatically abort connection fail after 2mins (Bluetooth only)
BUGFIX: Fast Gas change near the ppO2 limit could cause switching to a non-available Gas #0
CHANGE: Code now called hwOS officially
BUGFIX: There was a 1:4096 chance that a portion of a dive was not stored correctly resulting in download issues
Details on the new hwOS: http://www.heinrichsweikamp.com/?id=335
Regards,
Matthias