forum.heinrichsweikamp.com

Hi,

A little technical question:

would it be possible to implement an automatic, user defined, setpoint change in CC?
Like giving a setpoint value from depth X to depth Y, an another one from depth Z to depth V, that would switch automticaly a the defined depth?

Some computers (Vision) can do so.

Thanks for thinking about it.

The old nexus also could do that, I also would think this feature
would be an advantage!

Regards

Peter

Hello,

While this is theoretically easy to implement I have some problems with any kind of automatic gas or SetPoint change. As far as I know the vision has a ppO2 monitor which provides some redundancy in switching the SetPoint.

regards,
Matthias