Page 1 of 1
How to display the countdown the stop times deco
Posted: 02 Jun 2015, 17:12
by gui8
I can't seem to make it appear on the monitor of my OSTC 2C the countdown the stop times deco. Only appears (in minutes) the duration of the stop at every share but not the countdown. How can I do?
Re: How to display the countdown the stop times deco
Posted: 02 Jun 2015, 19:35
by kaheksa
The countdown in seconds is only on the safetystop not the decostop. Decostop only in minutes
-------------
Re: How to display the countdown the stop times deco
Posted: 03 Jun 2015, 13:05
by heinrichsweikamp
Hello,
The indicated deco is always based on the current tissue load and the predicted (Configured) gas chances. If you stay at the displayed deco depth time will decrease automatically.
Hope this is clear now
regards,
Matthias
Re: How to display the countdown the stop times deco
Posted: 03 Jun 2015, 19:14
by gui8
Thanks Matthias, the problem was to understand if you could display a countdown to deco stops, as happens for example in my Galileo SOL
Re: How to display the countdown the stop times deco
Posted: 04 Jun 2015, 10:52
by heinrichsweikamp
A seconds-countdown? No.
regards,
Matthias
Re: How to display the countdown the stop times deco
Posted: 04 Jun 2015, 17:34
by gui8
I think I would be very useful, when there are 10 - 15 minutes of decompression to do one must wait for the deadline without having immediate references ...
You cannot implement this feature in new version of firmware?
Re: How to display the countdown the stop times deco
Posted: 25 Aug 2015, 14:37
by Touchwood
Whatever way it's displayed you'll still have to wait until it is zero so what's the difference?
I can't see this as being of any use really. Minutes are small enough if you've got an hour to do.