Started in dive mode on land
Posted: 13 Jul 2009, 10:40
I had a problem yesterday with my OSTC with 1.40 - when I powered it up on land to calibrate my O2-sensors it immediately went into dive mode, displaying 99.9m depth.
I couldn't turn it off or reset it. Tried lowering it into 2m of water, hoping the pressure change would have some effect which it didn't. Still ticking when I came home 14 hours later.
Haven't connected it to my PC yet, but I suppose that or a flat battery is the only way to reset it?
Anyone experienced this?
I couldn't turn it off or reset it. Tried lowering it into 2m of water, hoping the pressure change would have some effect which it didn't. Still ticking when I came home 14 hours later.
Haven't connected it to my PC yet, but I suppose that or a flat battery is the only way to reset it?
Anyone experienced this?