Hello everyone
I'm new on this forum, but I'm happy owner HW ostc 2c from last 4 years.
I think is time to replace USB plug o-ring. I'm not sure about the dimensions.
I measured the size of the plug (o-ring channel) and it says that I should fit an oring with dimensions: 9,5x1,5 Is this correct? If not-can anyone give me the correct dimensions?
regards
Dariusz
OSTC 2C O-ring size
Re: OSTC 2C O-ring size
Hello Dariusz
According to an answer on the same question in this forum from May 29, 2015 there are two possible o-ring dimension (inside diameter x cross section):
10 x 1.3 mm, NBR 70 shore (old version)
8.5 x 2 mm, NBR 70 shore (new version)
Best regards
Michael
According to an answer on the same question in this forum from May 29, 2015 there are two possible o-ring dimension (inside diameter x cross section):
10 x 1.3 mm, NBR 70 shore (old version)
8.5 x 2 mm, NBR 70 shore (new version)
Best regards
Michael
Grüsse/Cheers Michi
OSTC 2C #7452
OSTCplus #17296
OSTC 2C #7452
OSTCplus #17296
Re: OSTC 2C O-ring size
Thank you Michael
-
- Posts: 4376
- Joined: Sunday 13. May 2007, 18:07
Re: OSTC 2C O-ring size
Hi,
Sorry for the delay. If you need O-Rings please send me a mail: info@heinrichsweikamp.com and we'll send some out for free.
Regards,
Matthias
Sorry for the delay. If you need O-Rings please send me a mail: info@heinrichsweikamp.com and we'll send some out for free.
Regards,
Matthias