forum.heinrichsweikamp.com

I was updating the firmware to latest from v2.15 when the upload hung up.
Tried to restart upload but the ostc companion software now tells me that my ostc3 is not an ostc3.
Was wanting to update software as the computer has been turning off whilst diving.

How to "factory reset ostc3?

Hi,

No need to do that, just install the lastest 2.97 as is. You don't need to "connect" first, just click on "Upgrade Firmware" as described in this link: http://forum.heinrichsweikamp.com/read.php?6,14509

Regards,
Matthias

Matthias.
I think by trying to update my software I was trying to fix this fault....

http://forum.heinrichsweikamp.com/read.php?6,19065

Shall I send my computer back to you?