Page 1 of 1
Firmware 3.20
Posted: Friday 14. October 2022, 21:23
by Regthing
Hello.
I upgraded to firmware 3.20 this afternoon on my OSTC plus as it was available through the config app. Went for 18m 45min dive this afternoon and the OSTC went a bit off the rails.
Screen shots attached
Re: Firmware 3.20
Posted: Friday 14. October 2022, 21:25
by Regthing
Screen shot might not have worked on the original post. Trying again here.
Re: Firmware 3.20
Posted: Friday 18. November 2022, 23:17
by henz
still can't see your screenshot
Re: Firmware 3.20
Posted: Tuesday 20. December 2022, 07:55
by scubatinoo
hwTech OS 3.20 is out and no announcement from heinrichsweikamp?
Re: Firmware 3.20
Posted: Tuesday 20. December 2022, 09:12
by gr3yw0lf
Regthing wrote: ↑Friday 14. October 2022, 21:23
Hello.
I upgraded to firmware 3.20 this afternoon on my OSTC plus as it was available through the config app. Went for 18m 45min dive this afternoon and the OSTC went a bit off the rails.
Screen shots attached
hm...
on my OSTC plus it is working - did several dives with 3.20 and no different behavior. compared with my shearwater it works like before.
it would be nice to get more information what you mean "off the rails". screenshot and error discription would be great.
or maybe it is just a usererror
Re: Firmware 3.20
Posted: Friday 13. October 2023, 03:34
by Regthing
Sorry for the late reply. By "off the rails" I mean it was showing me at 999m and a water temp of 999°C :o
I returned it to HW and they replaced the sensor. It was working fine until the last dive. Battery fully charged Thursday evening for a 35 min dive, 40 min dive on Friday morning, then 7 mins into a 14 min deco dive on Friday afternoon it went black :roll: