Compass - bearing
Posted: Friday 19. April 2024, 19:12
Hello,
For my new OSTC +, firmware V10.77, I can set the Bearing (Cap for the French interface), with the right push button.
When Bearing/cap is marked, in yellow, not in green as mentioned in the latest instructions, there is no problem.
Under water, with the bearing previously marked, the information is not displayed anymore, and when I attempted to set a new bearing, impossible, an other information was displayed (dive time??).
Compass calibration had been done, and the compass works fine over and under water.
Any idea if a specific configuration must be down?
Thanks in advance if your ideas!
Didier
For my new OSTC +, firmware V10.77, I can set the Bearing (Cap for the French interface), with the right push button.
When Bearing/cap is marked, in yellow, not in green as mentioned in the latest instructions, there is no problem.
Under water, with the bearing previously marked, the information is not displayed anymore, and when I attempted to set a new bearing, impossible, an other information was displayed (dive time??).
Compass calibration had been done, and the compass works fine over and under water.
Any idea if a specific configuration must be down?
Thanks in advance if your ideas!
Didier