forum.heinrichsweikamp.com

Hi

I'd like the logbook dive number in a new OSTC to be set to a specific number so I can keep track of the dives I've already made.
I understand this is done using the “Logbook Offset” function, but I don’t quite understand it yet.
Given that I’ve already logged one dive and that dive is listed as No. 1 in the logbook.
What steps should I take to make that dive listed as No. 1 become No. 1130?
And how can I ensure that subsequent dives continue the sequence starting from No. 1130?

Thank you

OSTC2 #19008

Hi,

Setup 1130 as the offset then. Please note that 4-digit offsets are only shown in the details view in the internal logbook, not in the listing view.

Matthias

Hi Mathhias,

Thanks for the quick response.
Done. Simple. ;)

Regards
Ion

[quote=heinrichsweikamp post_id=25520 time=1791838039 user_id=148]
...Please note that 4-digit offsets are only shown in the details view in the internal logbook, not in the listing view.
[/quote]

That's a shame. My listing view start with "000" again too... :-) Why isn't it possible to show the correct divenumber? Fonts could be smaller - back on surface i wear my glasses and i'm able to read smaler digits ;-)