Big bug!
Posted: Thursday 12. June 2008, 23:22
Hi,
I've been diving with the OSTC several times since last week. Firmware installed was 1.11.
No problem until today.
Today I installed firmware 1.14, and after installing, when I enter the menu, the computer gets out of the menu by itself, and even goes into Dive mode!
Also, at the place where the mix digit is supposed to appear, I get letters, constantly changing!
I tried to go back to firmware 1.11, even 1.08, the problem remains.
This seems to be a serious hardware problem.
Maybe a leak?
Today after a dive, I noticed there was a little bit of water behind the seal, at connector level...
Seal problem maybe?
Thanks for your help,
Maurice
I've been diving with the OSTC several times since last week. Firmware installed was 1.11.
No problem until today.
Today I installed firmware 1.14, and after installing, when I enter the menu, the computer gets out of the menu by itself, and even goes into Dive mode!
Also, at the place where the mix digit is supposed to appear, I get letters, constantly changing!
I tried to go back to firmware 1.11, even 1.08, the problem remains.
This seems to be a serious hardware problem.
Maybe a leak?
Today after a dive, I noticed there was a little bit of water behind the seal, at connector level...
Seal problem maybe?
Thanks for your help,
Maurice