Page 1 of 1
Connection
Posted: 30 Sep 2010, 18:00
by oxtox
Tried to download my dives to Jdivelog and get this message
Transfer Failed/Driver not set
Could not load data/The com port has not been specified
I have installed the FT232R driver
What to do?
Re: Connection
Posted: 30 Sep 2010, 18:37
by heinrichsweikamp
Hi,
Check 'Settings -> Divecomputer', choose
- OSTC
- The correct COM-Port from the list (If have nothing new installed lately it's usually the last one in the list)
- 'Protocol Version -> Auto'
It's time for a FAQ
regards,
Matthias
Re: Connection
Posted: 30 Sep 2010, 19:30
by oxtox
Hi
Check 'Settings -> Divecomputer', choose
- OSTC /// Already done that
- The correct COM-Port from the list (If have nothing new installed lately it's usually the last one in the list) /// There is no com-port to chose??
Have also tried to reinstall the driver, but it did not work anyway
Re: Connection
Posted: 30 Sep 2010, 19:37
by heinrichsweikamp
Try install the 'RXTX' Library during the installation of JDiveLog (In the installation dialog)...