HUD setup Mk1
Posted: Saturday 30. October 2010, 21:28
Hi all...
I am trying to figure out how to connect my LEDs to the O2-board. I am looking at connecting 2 cells for the OSTC and the HUD to read.
I have tired with 1 cell and everything works perfect..I have LEDs that change color with changed polarity so...under 1,0 I get red blink and over 1,0 I get Green blinks...this is OK with me even though there is a gap between 0,9 and 1,1 were the LED is not showing anything...can you change this?
So, to the problem...I thought that i could just connect a second cell to the slots on the O2 - board! But no...the second LED is not showing anything.
Everything is showing on the O2 module on the Mk1 screen...(the 2 cells, ppo2 and mV) what am I doing wrong?
Aswell the pricipal screen on the Mk1 only show 1 ppo2 readout...is this an average of the two cells?
Please help:))
Regards Mattias
I am trying to figure out how to connect my LEDs to the O2-board. I am looking at connecting 2 cells for the OSTC and the HUD to read.
I have tired with 1 cell and everything works perfect..I have LEDs that change color with changed polarity so...under 1,0 I get red blink and over 1,0 I get Green blinks...this is OK with me even though there is a gap between 0,9 and 1,1 were the LED is not showing anything...can you change this?
So, to the problem...I thought that i could just connect a second cell to the slots on the O2 - board! But no...the second LED is not showing anything.
Everything is showing on the O2 module on the Mk1 screen...(the 2 cells, ppo2 and mV) what am I doing wrong?
Aswell the pricipal screen on the Mk1 only show 1 ppo2 readout...is this an average of the two cells?
Please help:))
Regards Mattias