Page 1 of 1
Please wait message after firmware update
Posted: 14 Sep 2011, 22:46
by Tom
Hi,
My OSTC Mk2 zas on firmware 1.9, so i tried to update it using the new bootlader. It failed beacuse it didnt find teh right com. So i went back and used the old one. It gave me a successfull upload message with an upload time of 24 seconds.
Now my OSTC only displays a red Please wait message.
So what do i do now ?
Re: Please wait message after firmware update
Posted: 14 Sep 2011, 22:50
by Tom
It came trough.
Maybe it would be nice to note this in the update info that it can take several minutes to initialise. It gave me a scare ...
Thx for listening anyway
Re: Please wait message after firmware update
Posted: 17 Sep 2011, 16:24
by MacGuyver
Yes, this should be a good idea to have a time indication how long the "PLEASE WAIT" message will stay on the OSTC.
In the Boodloader you recieve a WRITE ok message but then the OSTC is still in "PLEASE WAIT".
Thx
Re: Please wait message after firmware update
Posted: 17 Sep 2011, 21:48
by JeanDo
In the beta announce, there was a warning in red to tell you you have to wait....
Re: Please wait message after firmware update
Posted: 22 Sep 2011, 16:53
by Dahab Boris
The "Please wait" can take some time - mine was approx 4-5 mins. Maybe it should say "Go and get a coffee, drink coffee and come back"
Re: Please wait message after firmware update
Posted: 29 Sep 2011, 22:02
by Decouverte
It scares me as well!
FYI, mine was in "Please wait" mode for over 9 minutes!!!
Re: Please wait message after firmware update
Posted: 30 Sep 2011, 09:15
by heinrichsweikamp
Normal, don't panic
Regards,
Matthias