Page 1 of 1
ostc/rEvo
Posted: 20 Feb 2009, 08:19
by jan
hi
i am thinking of upgrading my Mccr to Eccr(hybride)
is anyone capable of helping me with the neccesary parts
and setup?
already have the ostc
living in belgium
Re: ostc/rEvo
Posted: 20 Feb 2009, 11:20
by servan
Hello,
Is it possible to drive the solenoid with the OSTC ?
Regards
Servan
Re: ostc/rEvo
Posted: 26 Feb 2009, 07:54
by sailor
Hello, i just post a reply from Matthias in another thread:
heinrichsweikamp Wrote:
-------------------------------------------------------
> Hello,
>
> An eCCR use with the OSTC is currently not
> supported and due to liability reasons not on our
> to-do list, sorry.
>
> A technically skilled person could attach a
> solenoid driver to the O2 monitor board. Firmware
> of the board is Open Source, too...
>
> Regards,
> Matthias