OSTC2n (v2.70) Surface Interval display in Gauge mode.

[Liam]

Hi all. The answer to this may be a short no. But here it goes.

Does anyone know if it is possible to display the Surface Interval on the surface whilst using the OSTC2n in gauge mode?

When in one of the 'computer' modes it will do this. But in gauge mode it shows a duration of 00:00 at all times.


Thanks in advance.


Liam.

[heinrichsweikamp]

No, the surface interval resets to zero when all tissues are back to normal. Since they haven't changed in gauge mode the surface interval does not work here.

Regards,
Matthias

[Liam]

Matthias, many thanks for your reply.