OSTC MK2 - TTS Figures

[Lee Hatton]

Hi All,

I Am using the MK2 on firmware version 1.8. Can anyone let me know, do the TTS figures given during the dive allow for all gas selections on the current list or are they worst case assuming gas#1 throughout the whole dive?

Great computer by the way, hope the good work continues.

Thanks

Lee

[JeanDo]

The NDL is for the current Gas.
The TTS is using all selectable (current + active ones width depth >0) gas.

[Lee Hatton]

Thanks JeanDo

[KaratSV]

On simulator TTS considers for the given gas, at switching on Deco gas - TTS recalculates, that very much it is not convenient!!!

Whether please it is possible to make that TTS reckoned with the account of all active Deco gases just as it works in VR3 or VRX? I Shall be strongly grateful.

I am sorry for early conclusions. Like valid TTS considers in view of all active gases.

[dmainou]

To include every gas you will need to model them into the simulation. That is, you need to make each gas active and provide a depth to swap into them.

It's already there you just need to model correctly.

D

[Solodiver]

This should also go to FAQ/sticky thread - pops up every other week...