Surface Interval in v1.90, problem?

[olibert]

Hi,

I upgraded to 1.90 and I see something weird with the "Surface Interval".
Try this a few minutes/hours after you complete a dive:
- the ostc is 'sleeping'. you wake it up and circle with
the RIGHT button until the "Surface Interval" is displayed.
For me it always starts at 00:00 and counts up from there.
If you wait, say 1 minute, the "Surface Interval" will count
up to 00:01 and so on. But I think it should display the total
time since I surfaced... (like it was in v1.80)

Can someone else please verify this, to see if it happens on
your ostc too?

Thanks,
Olibert

[RCR Diver]

Mine stays at 00:00 and does not change at all. I agree that it should display the total time since I surfaced... (like it was in v1.80)

Pro Patria

[olibert]

I is weird/worrying: I made another dive and this time it worked out. I had the
minutes counting. Even after all desat was completed... I will keep trying and
report back...

Olibert

[heinrichsweikamp]

Hello,

The surface interval is increased when there is some desat-time left. If desat-time get's zero the surface interval is cleared.

regards,
Matthias