forum.heinrichsweikamp.com

After a brief look at 1.26 it looks promising.

Questions regarding:

NEW: Added Menu entry "Calibrate x %O2" in "O2 Sensor Menu"

NEW: Added CF37: HUD style (OSTC, DS1, RGB, Smithers) (OEM O2 sensor electronic)

1. Yes I find the Calibrate x %O2, where do I set what PO2 to calibrate to?

2. The setup #37 states HUD style [0-3] but there is three possible values, which is 0,1,2? I guess 3 is not valid?

andersnasman Wrote:
> 1. Yes I find the Calibrate x %O2, where do I set
> what PO2 to calibrate to?

That's your Diluent or "Start Gas" in Menu -> Gas Setup

> 2. The setup #37 states HUD style [0-3] but there
> is three possible values, which is 0,1,2? I guess
> 3 is not valid?

0=OSTC
1=DS1
2=RGB
3=Smithers

The new HUD styles require the ppO2 monitor board with firmware 1.1 or later.

Cheers,
Matthias