forum.heinrichsweikamp.com

Hi,

Thanks for your answer.

Regards,
Alain

Hi,

Here are the configuration settings:

[attachment=0]IMG_20240911_184604_cr.jpg[/attachment]

Whatever simulation or real dive I perform, after the dive, at the surface, the information 0 m 1' and DTR 1 are displayed.
In simulation mode, it is not necessary to perform the whole of the planed ...

Hi Matthias,

I don't enable GF, I only use saturation/desaturation %.
Note that I'm able to reproduce this behaviour in simulation mode.

Regards,
Alain

Hello Michi,
Thanks for your answer.

DTR means TTS, but I don't understand why it appears when I reach the surface. Like 0 m 1' !

Best regards,
Alain

Good evening,
After the dive, when I reach the surface, the following information is displayed for a while:
- 0 m 1'
- DTR 1'
There's also a little arrow with a time under the total dive time.
What does this information correspond to ?
SW release: 10.80

Thanks
Alain

[attachment=0]IMG_20240906 ...

Good morning,
Configuration: OSTC Sport - Firmware 10.71

I just come back from a liveaboard in Egypt and during the trip I needed to remplace the battery after 23 dives. The problem is that all the deco/saturation parameters were reset.
Is this the the expected behaviour ? I expected that these ...

Hello Ralph,

Thanks for your answer.

I don't often use the electronic compass so I prefer the OSTC spent more CPU time for diving calculation than compass management.

Regards,
Alain

Good morning,

Since I have upgraded my OSTC Sport with the new firmware 10.57, I have a strange behaviour of the compass.
Both in simulation mode or during a dive, the yellow line of the compass is flashing !
Furthermore when moving the compass, the refresh of the display is slow and jerky.

Thanks ...